Re: Info VLAN Disaggregation NTOPNG

Hi,

Yes after setting VLAN-based disaggregation i restart ntopng. No i
don't see any VLAN values greater than zero whitin ntopng. No any
interface come out from the Interfaces menu when enable VLAN
disaggregation. The only interface that i see are the local interface
of the VW where ntopng is installed and the nProbe interface of zmq,
the same that i see when i select none like disaggregation level


Simone Mainardi <[email protected]> ha scritto:

> Hi,
>
> Do you see VLAN values greater than zero within ntopng? Did you
> restart ntopng after setting VLAN-based disaggregation? Does any new
> interface come out from the Interfaces dropdown menu when the
> VLAN-based disaggregation i enabled?
>
>> On 28 Jun 2018, at 03:22, Flavio Baccaglini
>> <[email protected]> wrote:
>>
>> Good Morning
>>
>> I have a ntopng/nprobe system that i use to collect the sflow data
>> from a switch. The version of ntopng is 3.4 stable. The system version
>> is Debian 9. My configuration of ntopng and nprobe are save in the
>> file that i enclose you. I want to make a dissagregation at VLAN
>> level, but when i set the value in preferences in ntopng the system
>> stop to collect the flow and don't do nothing. I try a disaggregation
>> level for interface and it works. Could someone help me, or tell me if
>> i have a configuration mistake o if there is an another problem?
>>
>> Thank you for the help, and sorry for the bad english
>> Baccaglini Flavio
>>
>> <nprobe.conf><ntopng.conf>_______________________________________________
>> Ntop mailing list
>> [email protected]
>> http://listgateway.unipi.it/mailman/listinfo/ntop
>
> _______________________________________________
> Ntop mailing list
> [email protected]
> http://listgateway.unipi.it/mailman/listinfo/ntop