Re: Ntopng versus Ntopng Edge for historical monitoring?

Hi,

What sort of TCP flags exactly does Ntopng normally monitor?

For us - each VLAN should have different address spaces, so I think we will
be OK with it (for now).

In our case, we have a multi-tenant office, with separate VLANs for each
tenant. We also have a separate VLAN for things like our AV (audio-visual)
equipment, another for printing devices, another for live-streaming etc.
The idea was to improve security, and also give us flexibility to
prioritise latency/bandwidth as needed.

So for example - for general office use, this would be behind say, the
live-streaming VLAN.

Regards,
Victor

On Wed, Aug 8, 2018 at 8:01 PM Emanuele Faranda <[email protected]> wrote:

> Hi,
>
> In general, traffic reports, dashboards, alerts are all common between
> ntopng and nedge.
>
> Here are some differences:
>
>     - nEdge does not support remote probes (no NetFlow/sFlow/SNMP
> monitoring)
>
>     - nEdge does not monitor TCP flags
>
>     - Currently nEdge does not split traffic by VLAN, so two hosts with
> the same IP address but different VLAN will be accounted as a single host
>
> In particular for VLAN support, we wish to know which are the people
> requirements and typical use cases to improve it. So if you have any
> suggestions, please give your feedback!
>
> Regards,
>
> Emanuele
>
> On 08/08/2018 10:42 AM, Victor Hooi wrote:
>
> Hi,
>
> Are there any differences between Ntopng and Ntopng Edge in terms of
> passive monitoring or historical traffic tracking features?
>
> Thanks,
> Victor
>
>
> _______________________________________________
> Ntop mailing [email protected]://listgateway.unipi.it/mailman/listinfo/ntop
>
>
> _______________________________________________
> Ntop mailing list
> [email protected]
> http://listgateway.unipi.it/mailman/listinfo/ntop

_______________________________________________
Ntop mailing list
[email protected]
http://listgateway.unipi.it/mailman/listinfo/ntop