Re: ntopng + nProbe and softflowd

Hi!

The configuration is quite minimalistic:

ntopng:

-G=/var/run/ntopng.pid
-i="tcp://192.168.224.10:5556"
-m="10.123.123.0/24,192.168.224.0/24"
--community

nprobe:

-G=/var/run/nprobe.pid
-i=none
-n=none
-3=6363
--zmq="tcp://*:5556"

For example I want to see the bandwith used by Netflix or IPTV or 
something like that.

Matthias

Am 07.02.19 um 17:30 schrieb Simone Mainardi:
> Hi Matt,
>
> Please, show the nProbe and ntopng configurations used. Reported behavior can be normal as softflowd flow reports are periodic (eg. every minute) so it's normal if you see spiky traffic.
>
>> On 7 Feb 2019, at 09:28, Matthias Brumm <[email protected]> wrote:
>>
>> Hi!
>>
>> At the moment I am trying to get the above setup running. softflowd is an a PFsense, nProbe on a Raspberry and ntopng on a Debian 9 VM. I do not get sufficiant data (only peaks of 20 to 200 Mbit/s and no stream of traffic).
>>
>> A ntopng on the PFsense is not working properly so I would like to try this way.
>>
>> Am I missing some options to calibrate the information? I left pretty much all of it alone.
>>
>> Matthias
>>
>> _______________________________________________
>> Ntop mailing list
>> [email protected]
>> http://listgateway.unipi.it/mailman/listinfo/ntop
> _______________________________________________
> Ntop mailing list
> [email protected]
> http://listgateway.unipi.it/mailman/listinfo/ntop

-- 
Unser Familien-Blog: https://brumm.family