Help configuring nProbe with ntopng

--===============6442412699577924189==
Content-Type: multipart/alternative; boundary="000000000000e645340592362720"

--000000000000e645340592362720
Content-Type: text/plain; charset="UTF-8"

Hello Everyone,

I require some assistance with the following.

I have already configured nProbe to list to accolade NIC card. Now I need
help in configuring ntopng so that it reads from nprobe.

The problem, my accolade cards do not have an IP address as this entire
setup is in Layer 2 mode. So I am not able to figure out how to use zmq in
the nprobe config file and utilise the same in the ntopng config file.

-- 
-=Srijan Nandi

--000000000000e645340592362720
Content-Type: text/html; charset="UTF-8"
Content-Transfer-Encoding: quoted-printable

<div dir=3D"ltr">Hello Everyone,<div><br></div><div>I require some assistan=
ce with the following.</div><div><br></div><div>I have already configured n=
Probe to list to accolade NIC card. Now I need help in configuring ntopng s=
o that it reads from nprobe.=C2=A0</div><div><br></div><div>The problem, my=
 accolade cards do not have an IP address as this entire setup is in Layer =
2 mode. So I am not able to figure out how to use zmq in the nprobe config =
file and utilise the same in the ntopng config file.<br clear=3D"all"><div>=
<br></div>-- <br><div dir=3D"ltr" class=3D"gmail_signature" data-smartmail=
=3D"gmail_signature"><div dir=3D"ltr"><div><div dir=3D"ltr"><div dir=3D"ltr=
">-=3DSrijan Nandi<br></div></div></div></div></div></div></div>

--000000000000e645340592362720--

--===============6442412699577924189==
Content-Type: text/plain; charset="us-ascii"
MIME-Version: 1.0
Content-Transfer-Encoding: 7bit
Content-Disposition: inline

_______________________________________________
Ntop mailing list
[email protected]
http://listgateway.unipi.it/mailman/listinfo/ntop
--===============6442412699577924189==--