Re: Fix AArch64 "$x" symbols

On 07/31/2014 03:03 PM, William Cohen wrote:

> Have you tried running the same experiment on x86-64 and compared
> the resulting output?  I suspect that the "$x" map to some methods
> but for some reason oprofile is not getting the right location/name
> and ends up with "$x".  It would be good to compare the output to
> get some clue what "$x" might be.  You might also use "opreport
> --detail --symbols" to see where the samples are actually recorded
> and see where those $x functions are being located.  The "--detail"
> will provide a huge amount of output.

Sure, x86-64 is fine: it doesn't have mapping symbols.  I can see all
the "$x" symbols in the symtab on AArch64.

Andrew.

------------------------------------------------------------------------------
Infragistics Professional
Build stunning WinForms apps today!
Reboot your WinForms applications with our WinForms controls. 
Build a bridge from your legacy apps to the future.
http://pubads.g.doubleclick.net/gampad/clk?id=153845071&iu=/4140/ostg.clktrk