Re: problems with pcnet_cs and powerpc

On Wed, Jul 02, 2003 at 06:12:35PM +0200, Oliver Kurth wrote:
> 
> It does not work. I tried replacing all occurences of insw and outsw 
> with insb and outb, then writing even bytes to offset+0 and odd bytes to 
> offset+1. No change at all...

Oh... it is more complicated than that.  There is a register setting
for 8/16 bit mode, now that I think about it.

Change:

    ei_status.word16 = 1;

to:

    ei_status.word16 = 0;

You'll also need to remove the odd-byte handling and fix "count" to be
in bytes rather than words, around the insw/outsw code.

> So I am stuck again. Do you know anyone with experience with 8390 type 
> hardware I can ask?

There are datasheets at http://pcmcia-cs.sourceforge.net/specs in the
National Semiconductor section.

-- Dave


-------------------------------------------------------
This SF.Net email sponsored by: Free pre-built ASP.NET sites including
Data Reports, E-commerce, Portals, and Forums are available now.
Download today and enter to win an XBOX or Visual Studio .NET.
http://aspnet.click-url.com/go/psa00100006ave/direct;at.asp_061203_01/01