Re: TI1225 on MIPS continued...

David Hinds <[email protected]> Fri, 18 Jul 2003 12:39:48 -0700
Newsgroups gmane.linux.pcmcia.devel
Message-ID <[email protected]>
On Fri, Jul 18, 2003 at 02:56:21PM -0400, Steven J. Hill wrote:

>    Jul 18 14:43:26 10 cardmgr[135]: socket 1: 3Com 589 Ethernet
>    Jul 18 14:43:26 10 kernel: eth1: 3Com 3c589, io 0x5110, irq 58,
>    	hw_addr 00:60:97:94:FF:5E

Is irq 58 the same irq as is used by the yenta driver?  (it should
be!)  Also, does the hw address match what is printed on the card?

> I then configure the network interface and attempt to ping it from
> my host PC and I get these messages:

Do you see any network activity, blinking LED's on the card or on your
hub/switch?

>    Jul 18 14:43:53 10 kernel: yenta_events:1 cb_event=00000000
>    Jul 18 14:43:53 10 kernel: yenta_events:2 cb_event=00000000
>    Jul 18 14:43:53 10 kernel: yenta_events: csc=00
>    Jul 18 14:43:53 10 kernel: yenta_events: events=00000000
>    Jul 18 14:43:53 10 kernel: yenta_events: events=00000000

This all must be some useless logging you've added to the yenta
driver.  I'd suggest removing it.  I suppose it is useful to tell you
that the 3c589 card is successfully generating interrupts.

> If I then do a 'ifconfig eth1':
> 
>    eth1      Link encap:Ethernet  HWaddr 00:60:97:94:FF:5E
>              inet addr:192.168.0.2  Bcast:192.168.0.255  Mask:255.255.255.0
>              UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>              RX packets:15 errors:0 dropped:0 overruns:0 frame:0
>              TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>              collisions:0 txqueuelen:100
>              RX bytes:1470 (1.4 KiB)  TX bytes:0 (0.0 b)

You do seem to be receiving packets.

> I am not transmitting any packets. If I try to ping from my board to the
> host I get 'connect: Connection refused'. So, next we try a Compact Flash
> card. It is recognized properly but then starts spitting out a ton of
> interrupts:

Again I'd turn off all the yenta spewage.

The IDE driver is kind of a black box to me; I don't have any good
ideas for figuring out why it is failing.

-- Dave


-------------------------------------------------------
This SF.net email is sponsored by: VM Ware
With VMware you can run multiple operating systems on a single machine.
WITHOUT REBOOTING! Mix Linux / Windows / Novell virtual machines at the
same time. Free trial click here: http://www.vmware.com/wl/offer/345/0