Re: Help in configuring a new card

Hello Dhinds,

The card works perfectly on windows. I am able to exchange AT commands with
the card in windows. It is a serial card. following is the output of
dump_cis, see if you can help me.
-------------------------------------output of dump_cis----------
Socket 1:
  dev_info
    no_info
  vers_1 4.1, "GPRS Modem", "", "", ""
  manfid 0x0279, 0x950b
  funcid serial_port
  serial_interface
    uart 16550 [space/mark/odd/even] [7/8] [1/1.5/2]
  config base 0x00f8 mask 0x000f last_index 0x04
  cftable_entry 0x01 [default]
    [rdybsy]
    Vcc Vnom 3300mV Vmin 3V Vmax 3600mV Istatic 300mA
      Iavg 300mA Ipeak 500mA
    io 0x03f8-0x0407 [lines=8] [8bit] [range]
    irq mask 0xffff [level] [shared]
  cftable_entry 0x05
    io 0x02f8-0x02ff [lines=10] [8bit] [range]
  cftable_entry 0x05
    io 0x03e8-0x03ef [lines=10] [8bit] [range]
  cftable_entry 0x04
    io 0x02e8-0x02ef [lines=10] [8bit] [range]
---------------------------end--------------------------

and following is the entry in the config file
--------------snip from config file----------
card "GPRS Modem"
  manfid 0x0279, 0x950b
  bind "serial_cs"
---------------------------end------------------------

Rgds,
Mayank