Re: ARM Paging Problems
Stephen Lim <[email protected]>
| Newsgroups | gmane.linux.ports.arm.general |
|---|---|
| Message-ID | <[email protected]> |
Hi, >From the logs I believe the command-line parameters are: console=ttyAM1 root=mtd:root rootfstype=jffs2 mtdparts=phys_mapped_flash:0x40000(boot)ro,-(root) I was under the impression that the APEX 1.3.2 boot-loader left a stub or datastructure in a known memory location that the Linux Kernel reads on initialization. http://www.simtec.co.uk/products/SWLINUX/files/booting_article.html#ATAG_MEM Though I may be wrong. How would I configure the "mem" parameter in the APEX boot loader? Thanks, Stephen On Tue, Jun 16, 2009 at 4:37 PM, Subramani Venkatesh<[email protected]> wrote: > Hi, > Could you email me what is your command line parameters, can you try > mem=64M, in your boot parameters. > > Regards, > Subbu > > ------------------------------------------------------------------- List admin: http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm FAQ: http://www.arm.linux.org.uk/mailinglists/faq.php Etiquette: http://www.arm.linux.org.uk/mailinglists/etiquette.php