Problem with SPI on S3C2412

José Miguel Gonçalves <[email protected]>
Newsgroups gmane.linux.ports.arm.general
Message-ID <[email protected]> 
Hi,

I am trying to setup Linux 2.6.27 on an embedded board with a S3C2412 SoC.
After setting some architecture specific configuration on 
/arch/arm/mach-s3c2412/, I have finally booted my board with success.
Now I am trying to access a temperature sensor that is connected to the 
SPI bus.
For this I am thinking to use the spidev userspace API. I have compiled 
spidev and spi_s3c24xx as modules. I'm able to load spidev but, when I 
modprobe spi_s3c24xx, I'm getting the following error:

modprobe: failed to load module spi_s3c24xx: No such device

Any idea of what could be the problem?

Regards,
José Miguel Gonçalves
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.