How to write data in S3C2440 board
"Sandeep G.R" <[email protected]>
| Newsgroups | gmane.linux.ports.arm.general |
|---|---|
| Message-ID | <[email protected]> |
Hi,
I am using S3C2440(ARM920T) board and i have ported linux and its
working fine and now i need to write some 8-bit data(say 0xAA) into the
memory and i should read that data and display in the terminal. how to
proceed with this.
--
Thanks & Regards,
SANDEEP G R,
_______________________________________________
linux-arm mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm