IDE driver for ARM
"Sandeep G.R" <[email protected]>
| Newsgroups | gmane.linux.ports.arm.general |
|---|---|
| Message-ID | <[email protected]> |
Hi,
I am using S3C2440 ARM9 board and linux-2.6.30.4 kernel is ported
and i am using the IDE of the board for our project application, the thing
is i have used the address bus LADD1, LADDR2, LADDR3 and data bus
LDATA0-LDATA7. Now i need to write some 8-bit data(say 0xAA) to the memory
location 0x0800_0000 (nGCS1) and check that data(0xAA) is available on the
data bus. How to do this in linux?
--
Thanks & Regards,
SANDEEP G R,
_______________________________________________
linux-arm mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm