Arm parallel port configuration

sneha prakash <[email protected]> Mon, 17 May 2010 11:45:08 +0530

Newsgroups	gmane.linux.ports.arm.general
Message-ID	<[email protected]>

 Hi ,

  I have written a parport driver, parport_arm which is mapped to GPIO pins
in arm9 controller.I am able to load and unload this driver as a module with
the kernel in the mx25board.I want help to configure lp module to make use
of my driver and send the data to parallel port pins.



 <[email protected]>

_______________________________________________
linux-arm mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm