gpio setting

sneha prakash <[email protected]> Fri, 14 May 2010 10:16:01 +0530

Newsgroups	gmane.linux.ports.arm.general
Message-ID	<[email protected]>

---------- Forwarded message ----------
From: sneha prakash <[email protected]>
Date: Thu, May 13, 2010 at 3:12 PM
Subject: arm gpio setting
To: [email protected]


Hi ,
        We are using i.mx 25 board which consists of arm9 controller.I need
to
        convert the CMOS connector in the board to parallel port pins.We
have to
        convert CMOS connector pins to GPIO pins using IOMUX
configuration.Could
        any one help me to configure GPIO pins as parallel port pins and to
set
        the base address.
Regards,
      sneha.

_______________________________________________
linux-arm mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm