ARM IOMUX GPIO SETTING
sneha prakash <[email protected]>
| Newsgroups | gmane.linux.ports.arm.general |
|---|---|
| Message-ID | <[email protected]> |
Hi ,
We are using i.mx 25 board which consists of arm9 controller.I need
to
convert the CMOS connector in the board to parallel port pins.We
have to
convert CMOS connector pins to GPIO pins using IOMUX
configuration.Could
any one help me to configure GPIO pins as parallel port pins and to
set
the base address.
Regards,
sneha.
_______________________________________________
linux-arm mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm