Re: PXA320 SDIO driver
Eric Miao <[email protected]>
| Newsgroups | gmane.linux.ports.arm.general |
|---|---|
| Message-ID | <[email protected]> |
On Tue, Aug 31, 2010 at 1:32 PM, hong zhang <[email protected]> wrote: > Eric, > > 1. My kernel is 2.6.10 that has drivers/mmc/host/pxamci.c too but no > arch/arm/mach-pxa/pxa320.c. > That's way too old. I suggest you either use the mainline version or the BSP from Marvell. > 2. My wifi is from REDPINE wifi with sdio interface. > Not sure about the support status of this wifi. > ---henry > > > --- On Mon, 8/30/10, Eric Miao <[email protected]> wrote: > >> From: Eric Miao <[email protected]> >> Subject: Re: PXA320 SDIO driver >> To: "hong zhang" <[email protected]> >> Cc: [email protected] >> Date: Monday, August 30, 2010, 8:47 PM >> On Tue, Aug 31, 2010 at 7:04 AM, hong >> zhang <[email protected]> >> wrote: >> > List, >> > >> > I look at arch/arm/mach-pxa subdirectory and only see >> em-x270.c has sdio related codes. >> > >> > Where should I look for PXA320 SDIO driver? >> > >> >> Hi Hong, >> >> The SDIO controller driver is already there in >> drivers/mmc/host/pxamci.c. >> >> The specific SDIO device driver really depends on what you >> are using. >> i.e. the SDIO driver for Marvell's 88E8385/8686 WiFi chip >> can be found >> in drivers/net/wireless/libertas/... >> >> > Any help will be appreciated! >> > >> > >> > ---henry >> > >> > >> > >> > >> > _______________________________________________ >> > linux-arm mailing list >> > [email protected] >> > http://lists.infradead.org/mailman/listinfo/linux-arm >> > >> >> _______________________________________________ >> linux-arm mailing list >> [email protected] >> http://lists.infradead.org/mailman/listinfo/linux-arm >> > > > >