Re: [PATCH v3] arm64: dts: broadcom: bcm2712: adjust display status

Florian Fainelli <florian.fainelli-dY08KVG/lbpWk0Htik3J/[email protected]>
Newsgroups gmane.linux.drivers.devicetree,gmane.linux.kernel.rpi,gmane.linux.ports.arm.kernel
Message-ID <[email protected]> 
From: Florian Fainelli <[email protected]>

On Sat,  1 Aug 2026 17:54:26 +0100, Peter Robinson <[email protected]> wrote:
> Typically non critical IP in a SoC are disabled by
> default in the SoC .dtsi and enabled on board specific
> configs. There are usecases, such as some CM5 carrier
> boards, where display output may not be desired or
> connected. So disable them on the SoC .dtsi and enable
> them on the RPi5 board.
> 
> Signed-off-by: Peter Robinson <[email protected]>
> Cc: Florian Fainelli <florian.fainelli-dY08KVG/lbpWk0Htik3J/[email protected]>
> Cc: Dave Stevenson <[email protected]>
> Cc: Andrea della Porta <andrea.porta-IBi9RG/[email protected]>
> Fixes: 25d77bdd7df2 ("arm64: dts: broadcom: Add display pipeline support to BCM2712")
> ---

Applied to https://github.com/Broadcom/stblinux/commits/devicetree-arm64/next, thanks!
--
Florian
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.