[PATCH 1/7] pmdomain: arm: Fix -EINVAL from scmi_pd_set_perf_state() on state 0
Praveen Talari <[email protected]> Wed, 05 Aug 2026 01:27:39 +0530
| Newsgroups | gmane.linux.kernel.spi.devel,gmane.linux.ports.arm.kernel,gmane.linux.power-management.general,gmane.linux.kernel,gmane.linux.ports.arm.msm,gmane.linux.serial,gmane.linux.drivers.i2c |
|---|---|
| Message-ID | <20260805-derive_clk_perf_tbl_from_perf_domain_opp_table-v1-1-61171ab1cdce@oss.qualcomm.com> |
Currently, scmi_pd_set_perf_state() treats a performance state of 0 as invalid and returns -EINVAL. As a result, devices attached to SCMI performance domains can report failures when relinquishing their performance vote. The OPP framework use performance state 0 to indicate that no performance vote is required. For example, dev_pm_opp_set_rate(dev, 0) is commonly used (by firmware or linux) when a device is runtime suspended. A zero performance state does not require any SCMI performance request to be sent. Treat it as a no-op and return success instead of reporting an error. Signed-off-by: Praveen Talari <[email protected]> --- drivers/pmdomain/arm/scmi_perf_domain.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/pmdomain/arm/scmi_perf_domain.c b/drivers/pmdomain/arm/scmi_perf_domain.c index 3693423459c9..e390f902a444 100644 --- a/drivers/pmdomain/arm/scmi_perf_domain.c +++ b/drivers/pmdomain/arm/scmi_perf_domain.c @@ -33,7 +33,7 @@ scmi_pd_set_perf_state(struct generic_pm_domain *genpd, unsigned int state) return 0; if (!state) - return -EINVAL; + return 0; ret = pd->perf_ops->level_set(pd->ph, pd->domain_id, state, false); if (ret) -- 2.34.1