Re: [PATCH v4 0/2] phy: rockchip: inno-hdmi: Change TMDS rate handling to configure() ops
Vinod Koul <[email protected]>
| Newsgroups | gmane.linux.kernel,gmane.linux.ports.arm.rockchip,gmane.linux.ports.arm.kernel |
|---|---|
| Message-ID | <[email protected]> |
On Mon, 18 May 2026 18:07:19 +0000, Jonas Karlman wrote:
> This series adds support for using phy_validate() and phy_configure()
> with this HDMI PHY as an alternative to current in-tree unused way of
> using PHY bus width to configure the TMDS character rate.
>
> The only known users that calls phy_set_bus_width() on this PHY are my
> out-of-tree HDMI 2.0 patches for Rockchip RK3228/RK3328, i.e. those
> originating from LibreELEC (also carried by other distros), the
> downstream vendor kernel uses a different implementation that also calls
> phy_set_bus_width() on this PHY.
>
> [...]
Applied, thanks!
[1/2] phy: rockchip: inno-hdmi: Add configure() and validate() ops
commit: 58ca6ff31f6e9f5edf2879b5d7dc7485e92a4931
[2/2] phy: rockchip: inno-hdmi: Remove deprecated way to configure TMDS rate
commit: 4ba747d3d69b12d1221cea23eec9f468ff221cd6
Best regards,
--
~Vinod