Re: (subset) [PATCH 0/3] arm64: dts: imx95-15x15-frdm: support CAN transceivers sharing a silent GPIO

[email protected]
Newsgroups gmane.linux.can,gmane.linux.kernel,gmane.linux.ports.arm.kernel,gmane.linux.drivers.devicetree
Message-ID <178604677653.439551.7004828276697704665.b4-ty@b4> 
From: Frank Li <[email protected]>


On Thu, 30 Jul 2026 12:33:25 +0800, [email protected] wrote:
> On the i.MX95 15x15 FRDM board the two CAN transceivers (attached to
> flexcan2 and flexcan5) share a single "silent" control pin, which is
> routed through the on-board PCAL6524 GPIO expander. Both transceiver PHY
> nodes therefore reference the same GPIO line for their silent-gpios
> property.
>
> This series makes that sharing work correctly and puts the transceivers
> into the proper default state:
>
> [...]

Applied to (imx/dt-indend), thanks!

[3/3] arm64: dts: imx95-15x15-frdm: fix duplicated can-phy node names
      commit: 7a6460ea60c5dff7240c6e3bc307aee252fe0483

Best regards,
--
Frank Li <[email protected]>
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.