Re: [PATCH v2 5/9] dt-bindings: usb: dwc3: Document ST STM32MP2 DWC3 xHCI USB controller

On Sun, Aug 16, 2026 at 11:37:07PM +0200, Marek Vasut wrote:
> +properties:
> +  compatible:
> +    const: st,stm32mp25-dwc3
> +
> +  reg:
> +    maxItems: 1
> +
> +  access-controllers:
> +    maxItems: 1
> +
> +  clocks:
> +    minItems: 3
> +    maxItems: 3
> +
> +  clock-names:
> +    items:
> +      - const: ref
> +      - const: bus_early
> +      - const: suspend
> +
> +  dr_mode:
> +    $ref: /schemas/types.yaml#/definitions/string
> +    enum: [host, peripheral, otg]
> +
> +  interrupts:
> +    maxItems: 1
> +
> +  phys:
> +    minItems: 1
> +    maxItems: 2
> +
> +  phy-names:
> +    minItems: 1
> +    items:
> +      - const: usb2-phy
> +      - const: usb3-phy
> +
> +  resets:
> +    minItems: 1

Hm? You keep coming with some odd style, not present in any other files.
Where do you see such code - property followed by minItems alone? This
applies to other places as well.

> +
> +  st,syscfg:
> +    $ref: /schemas/types.yaml#/definitions/phandle-array
> +    description: Phandle to system configuration controller.
> +    items:
> +      - items:
> +          - description: phandle to syscfg
> +          - description: USB3DR control offset within syscfg
> +
> +  st,enable-port-power-control:
> +    type: boolean
> +    description: Enable Host-Mode Port Power Control (bit-3 of capability param HCCPARAMS)

Why wouldn't this be enavled always? Why is this a board-level property?

> +
> +  st,ovrcur-active-low:

Don't re-invent stuff:
st,over-current-active-low

> +    type: boolean
> +    description: Over-Current signal polarity is active-low
> +
> +  st,vbusen-active-low:
> +    type: boolean
> +    description: VBUS-ENABLE signal polarity is active-low
> +
> +required:
> +  - compatible
> +  - reg
> +  - clocks
> +  - clock-names
> +  - interrupts
> +  - phys
> +  - phy-names
> +  - resets
> +  - st,syscfg
> +
> +unevaluatedProperties: false

So where did you reference any other schema - for properties here and
for this unevaluatedProps?

> +
> +examples:
> +  - |
> +    #include <dt-bindings/clock/st,stm32mp25-rcc.h>
> +    #include <dt-bindings/interrupt-controller/arm-gic.h>
> +    #include <dt-bindings/reset/st,stm32mp25-rcc.h>
> +
> +    usb3dr: usb@48300000 {

Drop unused label

> +        compatible = "st,stm32mp25-dwc3";
> +        reg = <0x48300000 0x100000>;
> +        clocks = <&rcc CK_KER_USB2PHY2>, <&rcc CK_BUS_USB3DR>, <&rcc CK_KER_USB2PHY2>;
> +        clock-names = "ref", "bus_early", "suspend";
> +        interrupts = <GIC_SPI 228 IRQ_TYPE_LEVEL_HIGH>;
> +        phys = <&usb2_phy>, <&usb3_phy>;
> +        phy-names = "usb2-phy", "usb3-phy";
> +        resets = <&rcc USB3DR_R>;
> +        st,ovrcur-active-low;
> +        st,syscfg = <&syscfg 0x4800>;
> +        st,vbusen-active-low;
> +    };
> -- 
> 2.53.0
>