Re: [PATCHv3] ASoC: xilinx: formatter_pcm: use more devm in probe

On Fri, 14 Aug 2026 13:44:28 -0700
Rosen Penev <[email protected]> wrote:

> Use devm_clk_get_enabled() to let the clock be enabled automatically
> and cleaned up on unbind, dropping the manual clk_prepare_enable() and
> clk_disable_unprepare() calls in probe and remove. As a result, move the
> clk struct member into probe, which is the only place it's used.
> 
> Simplify the probe error paths by returning directly instead of
> jumping to clk_err, and use devm_snd_soc_register_component() return
> value directly. Also remove error message from ioremap as it throws one
> itself. Same with devm_request_irq().
> 
> Assisted-by: opencode:deepseek-v4-flash-free
> Signed-off-by: Rosen Penev <[email protected]>
> Reviewed-by: Michal Simek <[email protected]>
> Reviewed-by: Vincenzo Frascino <[email protected]>
> ---
>  v3: rebase.
>  v2: add signed-off-by. Further clean up some stuff.
>  sound/soc/xilinx/xlnx_formatter_pcm.c | 71 ++++++++-------------------
>  1 file changed, 20 insertions(+), 51 deletions(-)
> 
> diff --git a/sound/soc/xilinx/xlnx_formatter_pcm.c b/sound/soc/xilinx/xlnx_formatter_pcm.c
> index 3d6f1e4046d8..5f63fb28ea5f 100644
> --- a/sound/soc/xilinx/xlnx_formatter_pcm.c
> +++ b/sound/soc/xilinx/xlnx_formatter_pcm.c
> @@ -82,7 +82,6 @@ struct xlnx_pcm_drv_data {
>  	int mm2s_irq;
>  	struct snd_pcm_substream *play_stream;
>  	struct snd_pcm_substream *capture_stream;
> -	struct clk *axi_clk;
>  	unsigned int sysclk;
>  };
>  
> @@ -596,30 +595,19 @@ static int xlnx_formatter_pcm_probe(struct platform_device *pdev)
>  	u32 val;
>  	struct xlnx_pcm_drv_data *aud_drv_data;
>  	struct device *dev = &pdev->dev;
> +	struct clk *axi_clk;
> +
> +	axi_clk = devm_clk_get_enabled(dev, "s_axi_lite_aclk");
> +	if (IS_ERR(axi_clk))
> +		return dev_err_probe(dev, PTR_ERR(axi_clk), "failed to get s_axi_lite_aclk");
>  
>  	aud_drv_data = devm_kzalloc(dev, sizeof(*aud_drv_data), GFP_KERNEL);
>  	if (!aud_drv_data)
>  		return -ENOMEM;
>  
> -	aud_drv_data->axi_clk = devm_clk_get(dev, "s_axi_lite_aclk");
> -	if (IS_ERR(aud_drv_data->axi_clk)) {
> -		ret = PTR_ERR(aud_drv_data->axi_clk);
> -		dev_err(dev, "failed to get s_axi_lite_aclk(%d)\n", ret);
> -		return ret;
> -	}
> -	ret = clk_prepare_enable(aud_drv_data->axi_clk);
> -	if (ret) {
> -		dev_err(dev,
> -			"failed to enable s_axi_lite_aclk(%d)\n", ret);
> -		return ret;
> -	}
> -
>  	aud_drv_data->mmio = devm_platform_ioremap_resource(pdev, 0);
> -	if (IS_ERR(aud_drv_data->mmio)) {
> -		dev_err(dev, "audio formatter ioremap failed\n");
> -		ret = PTR_ERR(aud_drv_data->mmio);
> -		goto clk_err;
> -	}
> +	if (IS_ERR(aud_drv_data->mmio))
> +		return PTR_ERR(aud_drv_data->mmio);
>  
>  	val = readl(aud_drv_data->mmio + XLNX_AUD_CORE_CONFIG);
>  	if (val & AUD_CFG_MM2S_MASK) {
> @@ -628,7 +616,7 @@ static int xlnx_formatter_pcm_probe(struct platform_device *pdev)
>  					       XLNX_MM2S_OFFSET);
>  		if (ret) {
>  			dev_err(dev, "audio formatter reset failed\n");
> -			goto clk_err;
> +			return ret;

Why not dev_err_probe() for this one?  Even though maybe deferred handling
isn't useful here (I haven't checked) it still gives more compact code.

>  		}
>  		xlnx_formatter_disable_irqs(aud_drv_data->mmio +
>  					    XLNX_MM2S_OFFSET,
..

>  	if (val & AUD_CFG_S2MM_MASK) {
>  		aud_drv_data->s2mm_presence = true;
> @@ -654,7 +639,7 @@ static int xlnx_formatter_pcm_probe(struct platform_device *pdev)
>  					       XLNX_S2MM_OFFSET);
>  		if (ret) {
>  			dev_err(dev, "audio formatter reset failed\n");
> -			goto clk_err;
> +			return ret;

As above, I'd go return dev_err_probe() everywhere you now return due to
the other cleanups.

>  		}
>  		xlnx_formatter_disable_irqs(aud_drv_data->mmio +