Joystick 'digital' support : OK

Hello everybody !

Excuse me for the last submitted gcpad driver, i was finally able to 
test it and i saw that it didn't work :(...
This new one was successfully tested :) (based on Pong by DesktopMan) ! 
It was submitted to the SF Patches Tracking System...

I decided to do not support analogical axis and buttons (triggers) 
because of the lack of a SI driver (with a 'timer' the latency was too 
important). But don't be afraid, digital buttons (even L and R) and axis 
are supported, this is enough to use with j2mdev (so, to have both a 
mouse and a joystick on your GameCube :D).

Regards, Free The Cube.

PS : You can find pre-compiled tool-chains (host:i686-linux, 
target:powerpc-linux) here (only avaible this week-end) : 
http://www710.univ-lyon1.fr/~c-vinc02/toolchains-x86-gc-linux.tar.bz2
features :
    - Binutils-2.14
    - GCC-3.2.2
    - GLIBC-2.3.2 with linux-threads add-on
If you want to rebuilt yours, here comes a [french] post about it : 
http://gc-hack.webheberg.com/forum/viewtopic.php?p=3475#3475




-------------------------------------------------------
SF.Net is sponsored by: Speed Start Your Linux Apps Now.
Build and deploy apps & Web services for Linux with
a free DVD software kit from IBM. Click Now!
http://ads.osdn.com/?ad_id=1356&alloc_id=3438&op=click