SDcard building

The best bet is usually to scrape off the solder mask and then bodge it 
to the exposed track. Theres a lot of examples of this over at the gcdev 
forum (http://www.gcdev.com/phpBB2/index.php).

[plug]
If you have problems, you can buy premade sd adaptors at my site 
http://www.gamesfairy.co.uk as well as preconfigured Action Replay.
[plug]

-Randomdude/Alan

> I'm building an SD card adapter. I'd love to hear from anyone that's
> done this before and has any suggestions. I bought a SD card connector
> (the female kind that receives a SD card) and opened up a third party
> memory card to pillage its connector. The memory card connector is
> just a card edge on the PCB, and the copper fingers are swallowed up
> entirely by the GameCube, so there doesn't seem to be any hope of
> soldering directly to the fingers. None of the important signals (cs,
> miso, mosi, clk) go through a via, so I can't get the signals there.
> The signals go straight into a block blob on the printed circuit
> board, so I can't solder to a leg on a chip either. In short, it
> doesn't look like this memory card's going to be of any use to me. The
> best bet seems to print my own circuit board, but I don't have any
> experience with that, and I doubt it would be cheaper than
> buying/importing a SD card adapter.
> 
> So, any suggestions? If you've built an adapter, how'd you do it?
> 
> Cheers,
> Shaun
> 
> 
> 
> --__--__--
> 
> _______________________________________________
> Gc-linux-devel mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/gc-linux-devel
> 
> 
> End of Gc-linux-devel Digest


-------------------------------------------------------
SF email is sponsored by - The IT Product Guide
Read honest & candid reviews on hundreds of IT Products from real users.
Discover which products truly live up to the hype. Start reading now.
http://ads.osdn.com/?ad_id=6595&alloc_id=14396&op=click