Re: Re: Problems using the new exi framework with nbd swap

On Tue, 2005-04-19 at 23:08 +0000, Albert Herranz wrote:
> Daniel Thompson <d.thompson <at> gmx.net> writes:
> > I have a recently built 2.6.11 kernel built from the patches in
> > http://www.gc-linux.org/down/isobel
> [...]
> > Unfortunately my kernel is panicing due to one of the BUGONs in the EXI
> > framework (the one that prevents us selecting an already selected EXI
> > channel). The death messages are as follows (I have had to guess the
> > first character since it was off the side of my TV):
> [...]
> > Any clues, ideas or experiments they think I should perform?
> 
> Hi,
> 
> Try cvs code (exi-hw.c) or disable preemption.

I wasn't running with pre-emption however I have updated to the CVS
version since it appears to have quite a lot of changes compared to the
one I was using.

Unfortunately I am still seeing a crash when the 'cube starts to swap a
little.

The bulk of the crash info is the same as before but I have observed a
different stack. Although the top is similar the bottom half looks less
broken than the other.

exi_run_command+0x288/2bc

exi_select+0x44/0x58
rtc_set_time+0x1c/0x68
gcn_set_rtc_time+0x30/0x44
timer_interrupt+0x168
ret_from_except+0x0/0x14
ppc6xx_idel+0xe4/0xf0
cpu_idle+0x28/0x38
rest_init+0x24/0x34
start_kernel+0x170/0x1a8

-- 
Daniel Thompson (Merlin) <[email protected]>
signature.asc? http://www.redfelineninja.dsl.pipex.com/signature.html

Did Sigmund's wife wear Freudian slips?

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.6 (GNU/Linux)

iD8DBQBCahrSrr8Ifkjg/MwRAqIBAJ9Sd34K88DaDFsJTx+CZeWZsKP+mQCfT6ru
eUjqSLZcKDPzAi3vpJut/Us=
=9KU3
-----END PGP SIGNATURE-----