Booting

Right then, I am in UK so my cube is a PAL cube (anyone else running PAL?)

It was bought mid december of last year.

Am using psoload v1.1 OSX/Linux port running on Linux. (Are we getting a
v2.0 OSX/Linux port?)

Can't seem to get it running in DolWin at all. Is there anything special
i need to do?

Could the fact that it is PAL be causing the boot only as far as PID hash
table?

Also would it be simple to check if the cube is PAL and enable the framebuffer
in PAL or PAL60 mode?

If so i would like to implement this as my tv doesn't do 60Hz to well :-(

To access the CVS properly i am guessing i register with SF then ask the
maintainer to add my username to CVS access?

If this is the case then could you add me Michael? my username is phreakster.

Good work on the doc gropeaz. Should be very helpful.

Mike




-------------------------------------------------------
The SF.Net email is sponsored by EclipseCon 2004
Premiere Conference on Open Tools Development and Integration
See the breadth of Eclipse activity. February 3-5 in Anaheim, CA.
http://www.eclipsecon.org/osdn