Re: [PATCH] powerpc/rtas_pci: No hotplug on permanently removed device on pSeries

Greetings,

Latest Patch tested 
: https://lore.kernel.org/linuxppc-dev/[email protected]/ 


I have tested latest patch in my environment. The patch fixes the issue 
reported.


On 25/08/26 8:46 pm, Harsh Prateek Bora wrote:
> Hi Tasmiya,
>
> There was a v2 posted here:
> https://lore.kernel.org/linuxppc-dev/[email protected]/ 
>
>
> Although a minor change in return value and re-ordering before 
> CONFIG_BLOCKED incorporated in v2, it's better to test v2 and provide 
> test feedback on the same.
>
> Thanks
> Harsh
>
> On 25/08/26 3:52 pm, tasmiya wrote:
>> Greetings,
>>
>> Tested-by: Tasmiya Nalatwad <[email protected]>
>> Reported-by: Tasmiya Nalatwad <[email protected]>
>>
>>
>> I have Tested the patch in my KVM guest environment with device 
>> passthrough via vfio, It works fine and fixes the issue.
>> Triggered EEH freeze beyond eeh_max_freezes to permanently remove the 
>> device, then hotplugged a new PCI device. Without the patch, the 
>> rescan attempted to bring back the permanently removed device. With 
>> the patch applied, the removed device is correctly skipped during 
>> rescan and only newly hotplugged device is seen in the guest.
>>
>>
>> Thank you,
>>
>> Tasmiya
>>
>>
>> On 27/04/26 8:25 am, Shivaprasad G Bhat wrote:
>>> The eeh_driver disables and offlines the PE permanently when it
>>> exceeds the freeze count beyond eeh_max_freeze within the last hour.
>>> The PE is only offline, so the device tree entries, eeh device
>>> references are all intact till the real unplug of the device from
>>> the guest/host takes place.
>>>
>>> On pSeries, with a new hotplug of any PCI device, the drmgr initiates
>>> a system-wide PCI rescan, which finds devices offlined by the 
>>> eeh_driver
>>> and there will be attempts to bring them online. This leads to
>>> recurring EEHs either at the config read time itself or a bit
>>> later depending on the type of the problem.
>>>
>>> For PowerNV, the commit d2b0f6f77ee5 ("powerpc/eeh: No hotplug on
>>> permanently removed dev") introduced the EEH_DEV_REMOVED flag to
>>> prevent such inadvertent rescans on hierarchical toplogies relavent in
>>> Baremetal setups. For pSeries, such topologies don't really make sense
>>> as the devices are either part of the same PE OR exposed as independent
>>> devices on multiple virtual PHBs. However, the inadvertent rescans are
>>> still a possibility with either hotplug of a new device or otherwise
>>> with manual system-wide pci bus rescan attempts.
>>>
>>> So the patch checks for EEH_DEV_REMOVED before allowing config space
>>> access just like PowerNV, making the PCI core omit the PE, and thus
>>> preventing subsequent EEH recurances. The patch is tested on PowerVM
>>> and KVM machines with single and multi-function devices, and on the
>>> devices behind a switch. The unplug of the affected devices post EEH
>>> removal is also working fine as expected.
>>>
>>> Signed-off-by: Shivaprasad G Bhat <[email protected]>
>>> References: d2b0f6f77ee5 ("powerpc/eeh: No hotplug on permanently 
>>> removed dev")
>>> ---
>>>   arch/powerpc/kernel/rtas_pci.c |    6 ++++++
>>>   1 file changed, 6 insertions(+)
>>>
>>> diff --git a/arch/powerpc/kernel/rtas_pci.c b/arch/powerpc/kernel/ 
>>> rtas_pci.c
>>> index fccf96e897f6..ce24b18712ca 100644
>>> --- a/arch/powerpc/kernel/rtas_pci.c
>>> +++ b/arch/powerpc/kernel/rtas_pci.c
>>> @@ -57,6 +57,9 @@ int rtas_pci_dn_read_config(struct pci_dn *pdn, 
>>> int where, int size, u32 *val)
>>>       if (pdn->edev && pdn->edev->pe &&
>>>           (pdn->edev->pe->state & EEH_PE_CFG_BLOCKED))
>>>           return PCIBIOS_SET_FAILED;
>>> +
>>> +    if (pdn->edev && pdn->edev->mode & EEH_DEV_REMOVED)
>>> +        return PCIBIOS_SET_FAILED;
>>>   #endif
>>>       addr = rtas_config_addr(pdn->busno, pdn->devfn, where);
>>> @@ -108,6 +111,9 @@ int rtas_pci_dn_write_config(struct pci_dn *pdn, 
>>> int where, int size, u32 val)
>>>       if (pdn->edev && pdn->edev->pe &&
>>>           (pdn->edev->pe->state & EEH_PE_CFG_BLOCKED))
>>>           return PCIBIOS_SET_FAILED;
>>> +
>>> +    if (pdn->edev && pdn->edev->mode & EEH_DEV_REMOVED)
>>> +        return PCIBIOS_SET_FAILED;
>>>   #endif
>>>       addr = rtas_config_addr(pdn->busno, pdn->devfn, where);
>>>
>>>
>>
>