Re: Sound problems with MOL on an OldWorld G3

Sounds like you have a hardware problem. I also have an older
Macintosh " Biege g3 300 mhz " and it works fine with Mac Os 10.3 ands
10.4, however I used Xpostfacto to intsall it.
http://eshop.macsales.com/OSXCenter/XPostFacto/

You also failed to mention if the sound card is working under OS 9,
does it work correctly with OS 9?

Jose :-)


On 1/25/06, Risto Suominen <[email protected]> wrote:
> Hello all,
>
> I installed MOL 0.9.70 on my OldWorld PowerMac G3. It seems usable,
> but the sound doesn't work. I run Ubuntu 4.10 with kernel 2.6.8.1, and
> I compiled MOL from source. The problems are dependent on the guest
> operating system:
>
> To be able to get Mac OS 9 to boot, I had to extract the ROM from
> another machine, a PowerMac 7600. With it, and oftree.8500, it boots
> with 'startmol --oldworld'. I put the Mol-audio extension to the
> Extensions folder. Maybe this was wrong? Is it only for NewWorld
> machines? Because when I start the Sound Control Panel, I get an error
> message on the linux terminal window, something like: Cannot find
> mol-audio node. I assume this refers to an oftree node. And: Cannot
> route interrupt for mol-audio. I don't remember the exact words.
>
> With OS X 10.2 I'm somehow closer to success. Maybe the machine is
> just too slow (233 MHz). I tried to produce sound by playing an MP3 in
> iTunes. When about 3 min. of a total of 3:15 has gone, unexpectedly,
> the sound starts, first in small pieces, and getting better.
>
> In both cases, I get no startboing. I tried with different versions,
> with and without OSS and ALSA, when compiling MOL. I have both ALSA
> modules and ALSA-OSS compatibility layer loaded in the kernel. Am I
> alone trying to run MOL on an OldWorld Mac? Any help and ideas are
> welcome.
>
> Regards,
> Risto Suominen
> _______________________________________________
> mol-general mailing list
> [email protected]
> http://lists.maconlinux.org/mailman/listinfo/mol-general
>