Re: MOL complains after running startmol -X

Mattias,

I finally got a response on #yellowdog. For some reason (I have a dual
processor) the kernel mods for MOL were only included on a single
processor kernel. I did get it up and running using this kernel when
booted. I installed the MOL drivers for networking,etc...after I
rebooted per the installer request I am getting an out of memory
mesage? I edited molrc.osx ahead of time and changed ram from 96 to
256 since I have 512 installed on this dual G4 1ghz Powermac. YDL has
a different revision level on the kmod-ppc. And I was unable to find
the source rpm for this distro..if you could help me out with that too
I would appreciate it. Now if I can just get it compiled into my dual
processor kernel...I will be set :-) Thanks it is great...

Vielen Dank,

Zarephath

On 4/2/06, Mattias Nissler <[email protected]> wrote:
> On Sun, 2006-04-02 at 13:55 -0500, Mel Herndon wrote:
> > I get a message stating that it needs the MOL kernel to run (startmol
> > -X). However YDL 4.1 yum list *mol lists both the mol-kmods.ppc and
> > mol.ppc are installed. I ran molvconfig and it went without incident.
> > What do I need to do to get it to run OS X 10.4.5? Is it related to
> > the fact that OS X resides on a different hard drive (hda12)? YDL 4.1
> > is installed on hdb....
>
> Could you please post the actual error message? Are you running a distro
> kernel or one that you build yourself? If that is the case you likely
> will have to rebuild the MOL kernel modules from source.
>
> Mattias
>
> _______________________________________________
> mol-general mailing list
> [email protected]
> http://lists.maconlinux.org/mailman/listinfo/mol-general
>