[PATCH 06/23] microblaze: allow pte_offset_map() to fail
Hugh Dickins <[email protected]>
| Newsgroups | gmane.linux.ports.riscv,gmane.linux.ports.arm.kernel,gmane.linux.ports.ia64,gmane.linux.ports.mips,gmane.linux.ports.parisc,gmane.linux.ports.ppc64.devel,gmane.linux.ports.sh.devel,gmane.linux.ports.sparc,gmane.linux.kernel,gmane.linux.kernel.mm |
|---|---|
| Message-ID | <[email protected]> |
In rare transient cases, not yet made possible, pte_offset_map() and pte_offset_map_lock() may not find a page table: handle appropriately. Signed-off-by: Hugh Dickins <[email protected]> --- arch/microblaze/kernel/signal.c | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) diff --git a/arch/microblaze/kernel/signal.c b/arch/microblaze/kernel/signal.c index c3aebec71c0c..c78a0ff48066 100644 --- a/arch/microblaze/kernel/signal.c +++ b/arch/microblaze/kernel/signal.c @@ -194,7 +194,7 @@ static int setup_rt_frame(struct ksignal *ksig, sigset_t *set, preempt_disable(); ptep = pte_offset_map(pmdp, address); - if (pte_present(*ptep)) { + if (ptep && pte_present(*ptep)) { address = (unsigned long) page_address(pte_page(*ptep)); /* MS: I need add offset in page */ address += ((unsigned long)frame->tramp) & ~PAGE_MASK; @@ -203,7 +203,8 @@ static int setup_rt_frame(struct ksignal *ksig, sigset_t *set, invalidate_icache_range(address, address + 8); flush_dcache_range(address, address + 8); } - pte_unmap(ptep); + if (ptep) + pte_unmap(ptep); preempt_enable(); if (err) return -EFAULT; -- 2.35.3