Re: [RFC PATCH v2 07/30] drivers/pci: SH7751 PCI Host bridge controller driver.

Bjorn Helgaas <[email protected]>
Newsgroups gmane.linux.kernel.pci,gmane.linux.ports.sh.devel
Message-ID <20230918193036.GA203163@bhelgaas>
On Wed, Sep 13, 2023 at 06:23:32PM +0900, Yoshinori Sato wrote:

See subject line comments at
https://lore.kernel.org/r/20230918191602.GA201859@bhelgaas

Please add a commit log.  Repeating the subject line is fine, but
there's a little more detail that could be included here, e.g., a hint
about what platforms this is useful for.

> + * SH7751 PCI driver
> + * Copyright (C) 2023 Yoshinori Sato
> + *

Spurious blank line.

> +#define pcic_writel(val, reg) __raw_writel(val, pci_reg_base + (reg))
> +#define pcic_readl(reg) __raw_readl(pci_reg_base + (reg))

Best to include a pointer to a struct in the macro arguments so this
doesn't depend on local variable names in the users.  See advk_readl()
and advk_writel(), for example.

> +DEFINE_RAW_SPINLOCK(pci_config_lock);

Should be static.

> +	pcic_writel(0x0c000000, SH7751_PCICONF5);
> +	pcic_writel(0xd0000000, SH7751_PCICONF6);
> +	pcic_writel(0x0c000000, SH4_PCILAR0);
> +	pcic_writel(0x00000000, SH4_PCILAR1);

The header file uses upper-case hex, but this file looks like mostly
lower-case.  Maybe make them consistent?

> + * Since SH4 only does 32bit access we'll have to do a read,
> + * mask,write operation.

This RMW corrupts some registers; see comments and warning in
pci_generic_config_write32().  A comment here is probably enough.

> + * We'll allow an odd byte offset, though it should be illegal.
> + */
> +static int sh4_pci_write(struct pci_bus *bus, unsigned int devfn,
> +			 int where, int size, u32 val)

> +static int area_sdram_check(void __iomem *pci_reg_base,
> +			    void __iomem *bcr,
> +			    unsigned int area)
> +{
> +	unsigned long word;
> +
> +	word = __raw_readl(bcr + SH7751_BCR1);
> +	/* check BCR for SDRAM in area */
> +	if (((word >> area) & 1) == 0) {
> +		pr_info("PCI: Area %d is not configured for SDRAM. BCR1=0x%lx\n",

Use dev_info().  Will require passing a controller struct around,
which is common style in drivers/pci/controller/.

> +	dev_info(&pdev->dev, "PCI core found at %p\n",
> +		pci_reg_base);

Use %pR.

> +	/* use round robin mode to stop a device starving/overruning */

overrunning

Bjorn
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.