Re: [PATCH 05/17] arch, mm: pull out allocation of NODE_DATA to generic code

Mike Rapoport <[email protected]>
Newsgroups gmane.linux.ports.mips,gmane.linux.kernel,gmane.linux.ports.arm.kernel,gmane.linux.ports.ppc64.devel,gmane.linux.ports.riscv,gmane.linux.ports.sh.devel,gmane.linux.ports.sparc,gmane.linux.acpi.devel,gmane.linux.drivers.devicetree,gmane.linux.kernel.cross-arch,gmane.linux.kernel.mm
Message-ID <[email protected]>
On Fri, Jul 19, 2024 at 05:07:35PM +0200, David Hildenbrand wrote:
> > > > -	 * Allocate node data.  Try node-local memory and then any node.
> > > > -	 * Never allocate in DMA zone.
> > > > -	 */
> > > > -	nd_pa = memblock_phys_alloc_try_nid(nd_size, SMP_CACHE_BYTES, nid);
> > > > -	if (!nd_pa) {
> > > > -		pr_err("Cannot find %zu bytes in any node (initial node: %d)\n",
> > > > -		       nd_size, nid);
> > > > -		return;
> > > > -	}
> > > > -	nd = __va(nd_pa);
> > > > -
> > > > -	/* report and initialize */
> > > > -	printk(KERN_INFO "NODE_DATA(%d) allocated [mem %#010Lx-%#010Lx]\n", nid,
> > > > -	       nd_pa, nd_pa + nd_size - 1);
> > > > -	tnid = early_pfn_to_nid(nd_pa >> PAGE_SHIFT);
> > > > -	if (tnid != nid)
> > > > -		printk(KERN_INFO "    NODE_DATA(%d) on node %d\n", nid, tnid);
> > > > -
> > > > -	node_data[nid] = nd;
> > > > -	memset(NODE_DATA(nid), 0, sizeof(pg_data_t));
> > > > -
> > > > -	node_set_online(nid);
> > > > -}
> > > > -
> > > >    /**
> > > >     * numa_cleanup_meminfo - Cleanup a numa_meminfo
> > > >     * @mi: numa_meminfo to clean up
> > > > @@ -571,6 +538,7 @@ static int __init numa_register_memblks(struct numa_meminfo *mi)
> > > >    			continue;
> > > >    		alloc_node_data(nid);
> > > > +		node_set_online(nid);
> > > >    	}
> > > 
> > > I can spot that we only remove a single node_set_online() call from x86.
> > > 
> > > What about all the other architectures? Will there be any change in behavior
> > > for them? Or do we simply set the nodes online later once more?
> > 
> > On x86 node_set_online() was a part of alloc_node_data() and I moved it
> > outside so it's called right after alloc_node_data(). On other
> > architectures the allocation didn't include that call, so there should be
> > no difference there.
> 
> But won't their arch code try setting the nodes online at a later stage?
> 
> And I think, some architectures only set nodes online conditionally
> (see most other node_set_online() calls).
> 
> Sorry if I'm confused here, but with now unconditional node_set_online(), won't
> we change the behavior of other architectures?

The generic alloc_node_data() does not set the node online:

+/* Allocate NODE_DATA for a node on the local memory */
+void __init alloc_node_data(int nid)
+{
+	const size_t nd_size = roundup(sizeof(pg_data_t), PAGE_SIZE);
+	u64 nd_pa;
+	void *nd;
+	int tnid;
+
+	/* Allocate node data.  Try node-local memory and then any node. */
+	nd_pa = memblock_phys_alloc_try_nid(nd_size, SMP_CACHE_BYTES, nid);
+	if (!nd_pa)
+		panic("Cannot allocate %zu bytes for node %d data\n",
+		      nd_size, nid);
+	nd = __va(nd_pa);
+
+	/* report and initialize */
+	pr_info("NODE_DATA(%d) allocated [mem %#010Lx-%#010Lx]\n", nid,
+		nd_pa, nd_pa + nd_size - 1);
+	tnid = early_pfn_to_nid(nd_pa >> PAGE_SHIFT);
+	if (tnid != nid)
+		pr_info("    NODE_DATA(%d) on node %d\n", nid, tnid);
+
+	node_data[nid] = nd;
+	memset(NODE_DATA(nid), 0, sizeof(pg_data_t));
+}

I might have missed some architecture except x86 that calls
node_set_online() in its alloc_node_data(), but the intention was to leave
that call outside the alloc and explicitly add it after the call to
alloc_node_data() if needed like in x86.

> -- 
> Cheers,
> 
> David / dhildenb
> 
> 

-- 
Sincerely yours,
Mike.
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.