Re: [PATCH v4 -next 13/15] x86: vdso: move the sysctl to arch/x86/entry/vdso/vdso32-setup.c
yukaixiong <[email protected]>
| Newsgroups | gmane.linux.ports.sh.devel,gmane.linux.kernel,gmane.linux.file-systems,gmane.linux.kernel.mm,gmane.linux.nfs,gmane.linux.network,gmane.linux.kernel.lsm |
|---|---|
| Message-ID | <[email protected]> |
On 2024/12/30 7:05, Brian Gerst wrote: > On Sat, Dec 28, 2024 at 10:17 AM Kaixiong Yu <[email protected]> wrote: >> When CONFIG_X86_32 is defined and CONFIG_UML is not defined, >> vdso_enabled belongs to arch/x86/entry/vdso/vdso32-setup.c. >> So, move it into its own file. >> >> Before this patch, vdso_enabled was allowed to be set to >> a value exceeding 1 on x86_32 architecture. After this patch is >> applied, vdso_enabled is not permitted to set the value more than 1. >> It does not matter, because according to the function load_vdso32(), >> only vdso_enabled is set to 1, VDSO would be enabled. Other values >> all mean "disabled". The same limitation could be seen in the >> function vdso32_setup(). >> >> Signed-off-by: Kaixiong Yu <[email protected]> >> Reviewed-by: Kees Cook <[email protected]> >> --- >> v4: >> - const qualify struct ctl_table vdso_table >> --- >> --- >> arch/x86/entry/vdso/vdso32-setup.c | 16 +++++++++++----- >> kernel/sysctl.c | 8 +------- >> 2 files changed, 12 insertions(+), 12 deletions(-) >> >> diff --git a/arch/x86/entry/vdso/vdso32-setup.c b/arch/x86/entry/vdso/vdso32-setup.c >> index 76e4e74f35b5..f71625f99bf9 100644 >> --- a/arch/x86/entry/vdso/vdso32-setup.c >> +++ b/arch/x86/entry/vdso/vdso32-setup.c >> @@ -51,15 +51,17 @@ __setup("vdso32=", vdso32_setup); >> __setup_param("vdso=", vdso_setup, vdso32_setup, 0); >> #endif >> >> -#ifdef CONFIG_X86_64 >> >> #ifdef CONFIG_SYSCTL >> -/* Register vsyscall32 into the ABI table */ >> #include <linux/sysctl.h> >> >> -static struct ctl_table abi_table2[] = { >> +static const struct ctl_table vdso_table[] = { >> { >> +#ifdef CONFIG_X86_64 >> .procname = "vsyscall32", >> +#elif (defined(CONFIG_X86_32) && !defined(CONFIG_UML)) > vdso32-setup,.c is not used when building UML, so this can be reduced > to "#else". > >> + .procname = "vdso_enabled", >> +#endif >> .data = &vdso32_enabled, >> .maxlen = sizeof(int), >> .mode = 0644, >> @@ -71,10 +73,14 @@ static struct ctl_table abi_table2[] = { >> >> static __init int ia32_binfmt_init(void) >> { >> - register_sysctl("abi", abi_table2); >> +#ifdef CONFIG_X86_64 >> + /* Register vsyscall32 into the ABI table */ >> + register_sysctl("abi", vdso_table); >> +#elif (defined(CONFIG_X86_32) && !defined(CONFIG_UML)) > Same as above. > > > >> + register_sysctl_init("vm", vdso_table); >> +#endif >> return 0; >> } >> __initcall(ia32_binfmt_init); >> #endif /* CONFIG_SYSCTL */ >> >> -#endif /* CONFIG_X86_64 */ > > Brian Gerst > . Hello all; I want to confirm that I should send a new patch series, such as "PATCH v5 -next", or just modify this patch by "git send-email -in-reply-to xxxxx",or the maintainer will fix this issue ?