[PATCH net-next 3/3] sh_eth: Use async pm_runtime_put()

There is no stringent need to power down the device immediately after a
register read, or after a failed open.  Relax power down handling by
replacing calls to synchronous pm_runtime_put_sync() by calls to
asynchronous pm_runtime_put().

Signed-off-by: Geert Uytterhoeven <[email protected]>
---
 drivers/net/ethernet/renesas/sh_eth.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/renesas/sh_eth.c b/drivers/net/ethernet/renesas/sh_eth.c
index f16a350736e1aa04..5a367c5523bb860f 100644
--- a/drivers/net/ethernet/renesas/sh_eth.c
+++ b/drivers/net/ethernet/renesas/sh_eth.c
@@ -2233,7 +2233,7 @@ static void sh_eth_get_regs(struct net_device *ndev, struct ethtool_regs *regs,
 
 	pm_runtime_get_sync(&mdp->pdev->dev);
 	__sh_eth_get_regs(ndev, buf);
-	pm_runtime_put_sync(&mdp->pdev->dev);
+	pm_runtime_put(&mdp->pdev->dev);
 }
 
 static u32 sh_eth_get_msglevel(struct net_device *ndev)
@@ -2447,7 +2447,7 @@ static int sh_eth_open(struct net_device *ndev)
 	free_irq(ndev->irq, ndev);
 out_napi_off:
 	napi_disable(&mdp->napi);
-	pm_runtime_put_sync(&mdp->pdev->dev);
+	pm_runtime_put(&mdp->pdev->dev);
 	return ret;
 }
 
-- 
2.43.0