[linux-sh:03283] Reg. IDE probe fails!

Hi,

I am trying to deploy 2.4.26 on SH 7751 Solution Engine,  The kernel works fine with RAMDISK and without ide.  But when i try to place the ide related option, it gets panic. while trying to access port 0x3f6 and 0x1f6.

I want to access CF on the board.  Is there any patch available to overcome this!

The kernel is unable to set irq for the USB controller and PCI-ISA part.  and it doesnt list support for the MRSHPC01, and ALi M1543C.

 

Thanks in advance,

regds,

Vijay

********************

sh+ipl 

********************

looking for ide devices ->

Disk drive detected: Hitachi XXM2.3.0 Rev 3.00 X0404 20031027142049 

starting ide devices ->

Set Transfer Mode result: 51 

Initialize Device Parameters result: 50 

IDLE result: 50 

> 2

Linux version 2.4.26-uc0 (achilles@enigma) (gcc version 3.2.3) #140 Sat Jul 10 15:05:26 IST 2004

chimera : 200.x mv name = SoluôionEngine7751 

On node 0 totalpages: 8192

zone(0): 8192 pages.

zone(1): 0 pages.

zone(2): 0 pages.

Kernel command line: console=ttySC1,115200 mem=32M console=ttySC1,115200 mem=32M root=/dev/hda1 sh_mv=SolutionEngine7751

chimera : in ide routine 400.3.b 

Setting GDB trap vector to 0x8c000100

CPU clock: 162.03MHz

Bus clock: 27.00MHz

Module clock: 2ÿ

On node 0 totalpages: 8192

zone(0): 8192 pages.

zone(1): 0 pages.

zone(2): 0 pages.

Setting GDB trap vector to 0x8c000100

CPU clock: 162.03MHz

Bus clock: 27.00MHz

Module clock: 27.00MHz

Calibrating delay loop... 161.38 BogoMIPS

Memory: 30744k/32768k available (2024k reserved including: 1175k kernel code, 203k data, 180k BSS, 60k init, 352k page map)

Dentry cache hash table entries: 4096 (order: 3, 32768 bytes)

Inode cache hash table entries: 2048 (order: 2, 16384 bytes)

Mount cache hash table entries: 512 (order: 0, 4096 bytes)

Buffer cache hash table entries: 1024 (order: 0, 4096 bytes)

Page-cache hash table entries: 8192 (order: 3, 32768 bytes)

CPU: SH7751

POSIX conformance testing by UNIFIX

PCI: Using configuration type 1

SH7751 PCI: Finished initialization of the PCI controller

PCI: Bad IRQ mapping request for slot 12

PCI: Bad IRQ mapping request for slot 15

Linux NET4.0 for Linux 2.4

Based upon Swansea University Computer Society NET3.039

Initializing RT netlink socket

CF route : p3_ioremap(paddr=0x18000000, psize=0x00001000, prot=0xa0000535)=0xc0100000

HD64461 configured at 0xb0000000 on irq 36(mapped into 72 to 87)

HD64461: enabling PCMCIA devices

Starting kswapd

pty: 256 Unix98 ptys configured

SuperH SCI(F) driver initialized

ttySC0 at 0xffe00000 is a SCI

ttySC1 at 0xffe80000 is a SCIF

pcnet32.c:v1.28 02.20.2004 [email protected]

PCI: Enabling device 00:00.0 (0000 -> 0003)

pcnet32: PCnet/FAST III 79C973 at 0x4000, 00 00 00 00 00 00 assigned IRQ 13.

eth0: registered as PCnet/FAST III 79C973

pcnet32: 1 cards_found.

Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4

ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx

probing for hda: present=0, media=32, probetype=ATA

bad PC-like io name for port 0x3f6 at 0x8c09a7d8

Unable to handle kernel NULL pointer dereference at virtual address 000003f6

pc = 8c011fea

Oops: 0001

PC : 8c011fea SP : 8dfebf10 SR : 40008100 TEA : 000003f6 Not tainted

R0 : 000003f6 R1 : 00000000 R2 : 40008100 R3 : 00000001

R4 : 8c12e418 R5 : 00000001 R6 : 00000001 R7 : 00000001

R8 : 000003f6 R9 : 00000008 R10 : 8c19a70c R11 : 8c19a65c

R12 : 8c018da0 R13 : 00000001 R14 : 00000000

MACH: 0020f795 MACL: 00000000 GBR : 00000000 PR : 8c01200c

Kernel panic: Attempted to kill init!



=============================================================

SH7751 Self Debugger Ver 1.0L

-------------------------------------------------------------

(C) Copyright 1995-2001. Hitachi.Ltd. All rights reserved.

=============================================================

H[elp] for help messages...

Ready >


		
---------------------------------
Do you Yahoo!?
Yahoo! Mail - 50x more storage than other providers!