Re: [linux-sh:03232] Re: SH SCI output weirdness...

On Wed, 2004-05-05 at 18:00, Paul Mundt wrote:
> On Wed, May 05, 2004 at 10:18:28AM -0400, Paul Mundt wrote:
> > That's a good point. In that case, I'll back it out for cpu_relax() and add
> > the hlt_counter back in for the idle loop. This should fix serial on ST40.
> > 
> cpu_relax() is now a do { } while (0). I've added cpu_sleep() for wrapping to
> sleep, and the idle loop now uses this. The hlt_counter check is added back
> in again, so disable_hlt() should do the right thing now.
> 
> Alex, does this resolve your serial problems on ST40?

Yes it does. Of course I still seem to be having problems getting my
network chip to work properly but thats another problem ;-)

-- 
Alex, homepage: http://www.bennee.com/~alex/
If you go on with this nuclear arms race, all you are going to do is
make the rubble bounce.
		-- Winston Churchill



-------------------------------------------------------
This SF.Net email is sponsored by Sleepycat Software
Learn developer strategies Cisco, Motorola, Ericsson & Lucent use to 
deliver higher performing products faster, at low TCO.
http://www.sleepycat.com/telcomwpreg.php?From=osdnemail3