Re: Device Not Selected Error

On Fri, 7 May 2004 14:17:47 +0800
[email protected] wrote:

> Hi,
>      I have a MS7751RSE01 evaluation board. I am trying to compile the
> correct sh-ipl to boot from pcmcia. So far, i have an ipl that can read the
> pcmcia card, but returns the err mesg, IDE not detected. I tried figuring
> out the cause, as it turns out, ide.ide_device_selection(0) returns -1. How
> do i correct this?

I've posted patch for sh-ipl+g to run on MS7751RSE01 before, as:
<http://sourceforge.net/mailarchive/forum.php?thread_id=3422835&forum_id=5348>
<http://tsukuba.m17n.org/linux-sh/ml/linux-sh/2003-11/msg00007.html>
Second link has a link to patch file.
If you have difficulty to get it, let me know and I'll post it again.

To get sh-ipl+g source from m17n.org CVS, please refer to section 3.2 of
buildproc_E.html in <ftp://ftp.aandd.co.jp/pub/linuxsh/buildproc/2.4.18/current/>.

=================================
Masahiro ABE, A&D Co., Ltd. Japan




-------------------------------------------------------
This SF.Net email is sponsored by Sleepycat Software
Learn developer strategies Cisco, Motorola, Ericsson & Lucent use to 
deliver higher performing products faster, at low TCO.
http://www.sleepycat.com/telcomwpreg.php?From=osdnemail3