Re: PPP Modem Hangup

In my options file, I have debug and kdebug 7.
This is all the logs I could get:


logcat:
09-04 14:44:21.829 24869 24869 I pppd    : Using interface ppp0
09-04 14:44:21.829 24869 24869 I pppd    : Connect: ppp0 <--> /dev/ttyMSM0
09-04 14:44:21.831 24869 24869 D pppd    : sent [LCP ConfReq id=0x28
<mru 128> <asyncmap 0xa0000> <magic 0x2fe08c15> <pcomp> <accomp>]
09-04 14:44:21.854 24869 24869 D pppd    : rcvd [LCP ConfReq id=0x28
<mru 128> <asyncmap 0xa0000> <magic 0x3ffaa0d> <pcomp> <accomp>]
09-04 14:44:21.854 24869 24869 D pppd    : sent [LCP ConfAck id=0x28
<mru 128> <asyncmap 0xa0000> <magic 0x3ffaa0d> <pcomp> <accomp>]
09-04 14:44:21.859 24869 24869 D pppd    : rcvd [LCP ConfAck id=0x28
<mru 128> <asyncmap 0xa0000> <magic 0x2fe08c15> <pcomp> <accomp>]
09-04 14:44:21.861 24869 24869 D pppd    : sent [IPCP ConfReq id=0x4f
<addr 0.0.0.0>]
09-04 14:44:21.880 24869 24869 D pppd    : rcvd [IPCP ConfReq id=0x28
<addr 10.0.0.1>]
09-04 14:44:21.880 24869 24869 D pppd    : sent [IPCP ConfAck id=0x28
<addr 10.0.0.1>]
09-04 14:44:21.882 24869 24869 D pppd    : rcvd [IPCP ConfNak id=0x4f
<addr 10.0.0.2>]
09-04 14:44:21.882 24869 24869 D pppd    : sent [IPCP ConfReq id=0x50
<addr 10.0.0.2>]
09-04 14:44:21.897 24869 24869 D pppd    : rcvd [IPCP ConfAck id=0x50
<addr 10.0.0.2>]
09-04 14:44:21.898 24869 24869 I pppd    : local  IP address 10.0.0.2
09-04 14:44:21.898 24869 24869 I pppd    : remote IP address 10.0.0.1
09-04 14:44:26.800 24869 24869 I pppd    : Modem hangup
09-04 14:44:26.800 24869 24869 I pppd    : Connect time 0.1 minutes.
09-04 14:44:26.800 24869 24869 I pppd    : Sent 0 bytes, received 1316 bytes.


dmesg:
3:msm_serial_geni0(53):131203 GICv3:190b6400.qcom,bwmon-llcc(32):86828
GICv3:19091000.qcom,bwmon-ddr(33):58165
[ 4529.150036] (cpu:irq_count)- 0:318453 1:255610 2:1953373 3:2116553
4:1351087 5:1350685
[ 4529.150116] (ipi:irq_count)- 0:3822209 1:149695 2:0 3:0 4:0 5:370658 6:0
[ 4530.754440] init: ... started service 'console' has pid 25224
[ 4530.759148] init: starting service 'audioserver'...
[ 4530.768765] init: ... started service 'audioserver' has pid 25225
[ 4530.769623] init: starting service 'vendor.audio-hal'...
[ 4530.779094] init: ... started service 'vendor.audio-hal' has pid 25226
[ 4530.779157] init: Service 'console' (pid 25224) exited with status 0
[ 4530.779181] init: Sending signal 9 to service 'console' (pid 25224)
process group...
[ 4530.779346] libprocessgroup: Successfully killed process cgroup uid
2000 pid 25224 in 0ms
[ 4530.780358] init: processing action (init.svc.audioserver=running)
from (/system/etc/init/audioserver.rc:35)
[ 4530.780380] init: service 'vendor.audio-hal' requested start, but
it is already running (flags: 4)
[ 4530.911254] healthd: battery l=100 v=4068 t=25.0 h=2 st=2 c=-116091
fc=3588000 cc=0 chg=u
[ 4530.985181] servicemanager: Found
android.hardware.bluetooth.audio.IBluetoothAudioProviderFactory/default
in device VINTF manifest.
[ 4530.986106] sd 0:0:0:0: [sda] Synchronizing SCSI cache
[ 4531.739378] healthd: battery l=100 v=4425 t=25.0 h=2 st=2 c=109499
fc=3588000 cc=0 chg=u
^[[A^[[A^[[A^[[A^[[A^[[A[ 4532.423386] logd: logdr: UID=1041 GID=1005
PID=25301 n tail=500 logMask=8 pid=25226 start=0ns deadline=0ns

On Tue, Sep 10, 2024 at 11:23 AM Michael Richardson <[email protected]> wrote:
>
>
> Devesh Chipade <[email protected]> wrote:
>     > I get the following output:
>
> Looks sane to me.
> I had problems with my ISP connection where one of their DSLAMs would not
> answer IPCP echo requests if there was already traffic flowing.  I had to
> turn off that check at my end, but you already did that.
>
> I think you'll have to enable lots more debuging, and maybe throw in a
> printf() here or there.