[PATCH net-next v3 1/1] ppp: Fix KMSAN warning by initializing 2-byte header

The PPP driver adds an extra 2-byte header to enable socket filters to run
correctly. However, the driver only initializes the first byte, which
indicates the direction. For normal BPF programs, this is not a problem
since they only read the first byte.

Nevertheless, for carefully crafted BPF programs, if they read the second
byte, this will trigger a KMSAN warning for reading uninitialized data.

Reported-by: [email protected]
Closes: https://lore.kernel.org/bpf/[email protected]/
Signed-off-by: Jiayuan Chen <[email protected]>
---
 drivers/net/ppp/ppp_generic.c | 15 +++++++++++----
 1 file changed, 11 insertions(+), 4 deletions(-)

diff --git a/drivers/net/ppp/ppp_generic.c b/drivers/net/ppp/ppp_generic.c
index 4583e15ad03a..29a7a21cb096 100644
--- a/drivers/net/ppp/ppp_generic.c
+++ b/drivers/net/ppp/ppp_generic.c
@@ -1762,10 +1762,17 @@ ppp_send_frame(struct ppp *ppp, struct sk_buff *skb)
 
 	if (proto < 0x8000) {
 #ifdef CONFIG_PPP_FILTER
-		/* check if we should pass this packet */
-		/* the filter instructions are constructed assuming
-		   a four-byte PPP header on each packet */
-		*(u8 *)skb_push(skb, 2) = 1;
+		/* Check if we should pass this packet.
+		 * The filter instructions are constructed assuming
+		 * a four-byte PPP header on each packet. The first byte
+		 * indicates the direction, and the second byte is meaningless,
+		 * but we still need to initialize it to prevent crafted BPF
+		 * programs from reading them which would cause reading of
+		 * uninitialized data.
+		 */
+		skb_push(skb, 2);
+		skb->data[0] = 1;
+		skb->data[1] = 0;
 		if (ppp->pass_filter &&
 		    bpf_prog_run(ppp->pass_filter, skb) == 0) {
 			if (ppp->debug & 1)
-- 
2.47.1