Re: Problem with getting a Canon Selphy CP790 to work on Mac OSX

On Sat, Jan 09, 2021 at 11:10:37PM +0100, Clemens Hartmann wrote:
> >The most likely explanation here is that your CP790 was inadvertantly
> >configured to use the standard 'usb' CUPS backend, rather than the
> >custom 'gutenprint53+usb' backend.
> 
> What can I do to make the printer use the correct backend ?

Clemens,

I'm sorry about the delay; this fell through the cracks over the holidays.

This email from our archive should have enough information to make that 
determination:

   https://sourceforge.net/p/gimp-print/mailman/message/37165463/

 - Solomon
-- 
Solomon Peachy			      pizza at shaftnet dot org (email&xmpp)
                                      @pizza:shaftnet dot org   (matrix)
High Springs, FL                      speachy (freenode)

_______________________________________________
Gimp-print-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/gimp-print-devel

-----BEGIN PGP SIGNATURE-----
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=M5dA
-----END PGP SIGNATURE-----