Re: Gimp-Print for M1 Big Slur iMac drivers?
Matt Broughton <[email protected]>
| Newsgroups | gmane.linux.printing.gimp-print.devel |
|---|---|
| Message-ID | <[email protected]> |
> On Jun 30, 2021, at 7:26 AM, Matt Broughton <[email protected]> wrote: > > > >> On Jun 28, 2021, at 6:01 AM, Danny Chiu via Gimp-print-devel <[email protected]> wrote: >> >> Hi Guys, >> >> Any chance you guys will be adding M1 Support? I’m having problems with my older Canon MG6270 Printer on Big Slur. It can use “Air Print” to print but the Image Capture, doesn’t see the scanner. >> >> Thanks, >> Danny > > Gutenprint does have plans to release a version that is native to the M1 chip. The current Mac release does work however with the M1 chip as long as Rosetta is installed. Sorry to say that Gutenprint does not support scanners. > > Matt Addendum. I tried Image Capture with my Epson three in one on Intel chipset. I don't think that Image Capture is designed to work with a scanner to print directly or automatically. It makes a scan and places the file on your hard disk for printing from a different application. I also ran into problems with Image Capture telling me that there was no document loaded. I had to set whether the document was on the flatbed or in the document feeder. I hope this helps., Also, you might want to check /Library/Image Capture/TWAIN Data Sources to see if the is an entry for Canon. Matt _______________________________________________ Gimp-print-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/gimp-print-devel