Re: was - P700 and P900 full channel support
Robert Krawitz <[email protected]>
| Newsgroups | gmane.linux.printing.gimp-print.devel |
|---|---|
| Message-ID | <[email protected]> |
On 10/31/21 9:22 AM, Walker Blackwell wrote: > The problem as I understand it from Roy Harrington is that ESCP/R (the protocol used to communicate with these newer printer) is a totally different and it's hard to identify channel selections (if channel selection are even a think anymore because it’s an RGB protocol apparently). But essentially you need to scrape the data from the USB communication or print-file? when you print a Photo Black glossy print and another one with Matte Black but essentially the same settings otherwise. This way it’s easier to identify any changes to the data. > > I’m sure Robert can elaborate. ESCP/R will not help with ESC/P2. If the driver is sending ESCP/R it isn't going to help me figure out the code for violet. Matte black usually has a certain code. The good news is that there aren't a lot of possibilities for what it can be. _______________________________________________ Gimp-print-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/gimp-print-devel