Re: Issue : CUPS En pause "printer error: No paper

Solomon Peachy <[email protected]> Thu, 4 Nov 2021 15:41:28 -0400

Newsgroups	gmane.linux.printing.gimp-print.devel
Message-ID	<[email protected]>

On Wed, Nov 03, 2021 at 11:40:43PM +0100, Quentin Vtt wrote:
> Everything work well until there is no paper in the canon Selphy CP1000
> 
> The state of the printer go to “En pause – “Printer error: No Paper (03)”
> 
> Even if load paper, turn Off then turn On the printer, the state in CUPS
> don’t change and there is no more print.

CUPS has no way of knowing that the printer error has been resolved; the 
presumption is that when the operator (ie you) resovles the issue, you 
then tell CUPS to re-start the queue.

> sudo cupsenable Canon_CP1000 work also

This is what I personally use.

> I read on the web that “ErrorPolicy retry-job” could solve this problem,
> but this rule seems to be already set by default in my CUPS version 2.2.10

ErrorPolicy only applies when the error is the more generic FAILED.

> To sum it up, the queue disabled correctly in CUPS because it is told to do
> so. 

Yes, this is the intended behavior, as the printer will not be capable 
of accepting new jobs until the error is resolved by the operator.

 - Solomon
-- 
Solomon Peachy			      pizza at shaftnet dot org (email&xmpp)
                                      @pizza:shaftnet dot org   (matrix)
High Springs, FL                      speachy (libra.chat)

_______________________________________________
Gimp-print-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/gimp-print-devel

signature.asc (application/pgp-signature, 833 B)