RE: i810 audio /dev/sound/dsp missing

If this is your board, then it doesn't have on-board audio and you must be
using an off-board one.

http://www.giga-byte.com/MotherBoard/Products/Products_GA-BX2000.htm
http://www.giga-byte.com/Motherboard/FileList/ProductImage/photo_bx2000s_big
.jpg

Please boot PXEs and flip over to console F3 or F4, and run
	cat /proc/pci
And look for anything relating to audio.

If your sound card is ISA you'll have to pull it out and look at it.

What made you think it was i810 audio?

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Ola Samuelson
Sent: Monday, 22 March 2004 9:08 p.m.
To: [email protected]
Subject: Re: [pxes-devel] i810 audio /dev/sound/dsp missing


Gigabyte BX2000. Should be 810 as far as i can tell.
In BIOS "AC97 AUDIO Enabled"

Craig FALCONER wrote:

>Either its not a i810 chipset / audio device, or
>its not supported by the i810 module in 2.4.20, or
>it isn't turned on in the bios.
>
>What is the motherboard exactly?
>
>
>
>-----Original Message-----
>From: [email protected]
>[mailto:[email protected]] On Behalf Of Ola 
>Samuelson
>Sent: Saturday, 20 March 2004 1:34 a.m.
>To: [email protected]
>Subject: [pxes-devel] i810 audio /dev/sound/dsp missing
>
>
>Hi!
>It almost works...... but the local audio.
>i get "/dev/sound/dsp missing" at boot and audio server can not be 
>started.
>
>I do not know what i am doing wrong here.
>If i force(or from the console load) ac97_codec there are no messages. 
>loadin i810_audio.o fails with  "no such device".
>
>So "/dev/sound/dsp missing"  shows even after successful loading of
>ac97_codec.
>
>Ideas?
>TIA
>//Ola
>//



-------------------------------------------------------
This SF.Net email is sponsored by: IBM Linux Tutorials
Free Linux tutorial presented by Daniel Robbins, President and CEO of
GenToo technologies. Learn everything from fundamentals to system
administration.http://ads.osdn.com/?ad_id70&alloc_id638&op=click