Re: PXES

There are no Gb Ethernet cards supported in PXES 0.8.
You should change the NIC or wait until next release.
Please use the mailing list.

On Mon, 2004-06-14 at 03:11, William A Maki wrote:
> Hello,
> 
> I am trying to use your software (ver 8.0) to boot a thin client from a 
> redhat 9.0 server. I have the dhcp server working.  The network card on 
> the client is a 82540EM Gigabit Ethernet Controller. On the redhat 
> server the driver I am using for this card is an e1000.o.
> 
> The thin client boots up into console mode and receives an ip address 
> and shows the boot screen. When I select an image to boot it loses the 
> connection after the statement "disabling console messages".
> 
> Could you please provide suggestions on how to make sure the 82540EM 
> Card functions properly on the client.
> 
> Thank you in advance for any help,
> 
> Bill Maki
> [email protected]



-------------------------------------------------------
This SF.Net email is sponsored by the new InstallShield X.
From Windows to Linux, servers to mobile, InstallShield X is the
one installation-authoring solution that does it all. Learn more and
evaluate today! http://www.installshield.com/Dev2Dev/0504