Re: PXES + Terminal Services 2003

Firstly, kindest regards to you, Andres, and all of the friends at
igalia.
You should have no problems using ACPI in PXES with 2.6 kernel. And if
you test your hardware with ACPI enabled in 2.4 and it works you could
obtain the same results.

But I have one question. Why do you want that just after log out the
computer turns off ? Is this not an unexpected (and perhaps annoying)
behavior ?
 
On Wed, 2005-08-31 at 06:07, Andres Gomez Garcia wrote:
> El lun, 29-08-2005 a las 14:15 +0000, Marcelo Renan Becher escribió:
> 
> > This script connect by telnet/ssh in pxes client, and runs "poweroff" 
> > command..
> 
> Ouch!! I was thinking "halt" and "poweroff" were just synonims. With my
> 2.4.20 ACPI & APM enabled kernel busybox command "poweroff" works fine.
> 
> Thanks.
> 
> Ciao.
-- 
Diego Torres Milano <[email protected]>
PXES Universal Linux Thin Client
http://pxes.sf.net



-------------------------------------------------------
SF.Net email is Sponsored by the Better Software Conference & EXPO
September 19-22, 2005 * San Francisco, CA * Development Lifecycle Practices
Agile & Plan-Driven Development * Managing Projects & Teams * Testing & QA
Security * Process Improvement & Measurement * http://www.sqe.com/bsce5sf