[RFC v2 3/5] md: rename mdstat action "recovery" to "recover"

From: Zheng Qixing <[email protected]>

Simplify the code in status_resync() that prints the progress of sync
actions.

Also rename the /proc/mdstat action from "recovery" to "recover" to
match the naming used by action_store() and action_show().

Note:
The md-raid-utilities/mdadm test suite will need to be updated to expect
"recover" instead of "recovery" in /proc/mdstat.

Signed-off-by: Zheng Qixing <[email protected]>
---
 drivers/md/md.c | 10 ++++------
 1 file changed, 4 insertions(+), 6 deletions(-)

diff --git a/drivers/md/md.c b/drivers/md/md.c
index 7fe02ee21d3e..f319621c6832 100644
--- a/drivers/md/md.c
+++ b/drivers/md/md.c
@@ -8669,6 +8669,7 @@ static int status_resync(struct seq_file *seq, struct mddev *mddev)
 	sector_t rt, curr_mark_cnt, resync_mark_cnt;
 	int scale, recovery_active;
 	unsigned int per_milli;
+	enum sync_action action;
 
 	if (test_bit(MD_RECOVERY_SYNC, &mddev->recovery) ||
 	    test_bit(MD_RECOVERY_RESHAPE, &mddev->recovery))
@@ -8750,13 +8751,10 @@ static int status_resync(struct seq_file *seq, struct mddev *mddev)
 			seq_printf(seq, ".");
 		seq_printf(seq, "] ");
 	}
+
+	action = md_sync_action(mddev);
 	seq_printf(seq, " %s =%3u.%u%% (%llu/%llu)",
-		   (test_bit(MD_RECOVERY_RESHAPE, &mddev->recovery)?
-		    "reshape" :
-		    (test_bit(MD_RECOVERY_CHECK, &mddev->recovery)?
-		     "check" :
-		     (test_bit(MD_RECOVERY_SYNC, &mddev->recovery) ?
-		      "resync" : "recovery"))),
+		   md_sync_action_name(action),
 		   per_milli/10, per_milli % 10,
 		   (unsigned long long) resync/2,
 		   (unsigned long long) max_sectors/2);
-- 
2.39.2