Re: [PATCH 2/7] md/raid1: handle atomic writes that require splitting

On 23/06/2026 11:06, Abd-Alrhman Masalkhi wrote:
> On Tue, Jun 23, 2026 at 10:20 +0100, John Garry wrote:
>> On 23/06/2026 09:58, Abd-Alrhman Masalkhi wrote:
>>> On Tue, Jun 23, 2026 at 09:11 +0100, John Garry wrote:
>>>> On 23/06/2026 08:24, Abd-Alrhman Masalkhi wrote:
>>>>> If a request already requires splitting when entering
>>>>> raid1_write_request(), the current code allows it to proceed until it
>>>>> eventually reaches the split path.
>>>>
>>>> The block layer should catch invalid atomic writes in
>>>> submit_bio_noacct() -> blk_validate_atomic_write_op_size() before we
>>>> even get as far as the md atomic write handling. Having the check in
>>>> bio_submit_split_bioset() is really just a fail-safe for the block layer
>>>> not catching invalid atomic writes or the atomic writes queue limits not
>>>> being properly calculated.
>>> The request size itself satisfies the currently advertised atomic write
>>> limits, so blk_validate_atomic_write_op_size() allows it. The problem
>>> is that RAID1 may further restrict atomic writes to a single barrier
>>> unit via align_to_barrier_unit_end(). Therefore a request that crosses
>>> a barrier-unit boundary can still reach raid1_write_request() with
>>> max_sectors < bio_sectors(bio).
>>>
>>> If the barrier-unit restriction should instead be advertised through the
>>> atomic write queue limits,
>>
>> It should. Any restrictions should be advertised up front. For the user
>> to issue an atomic write which is valid according to limits, then it
>> should succeed.
>>
> 
> I'll take a look at how best to expose that through the queue limits and
> rework this part accordingly. If there is already an existing mechanism
> you had in mind, I'd appreciate any pointers.

Any write must fit within BARRIER_UNIT_SECTOR_SIZE, right?

Since an atomic write must be naturally aligned, then I would expect 
that the atomic write max unit is limited by BARRIER_UNIT_SECTOR_SIZE.

> 
>>> then I agree the block layer could reject
>>> such requests earlier and the RAID1 entry check would become
>>> unnecessary.
>>>
>>> However, there are also cases where max_sectors is reduced later within
>>> raid1_write_request(), for example when bad blocks are present on some
>>> mirrors (or due to other RAID1-specific constraints such as write-behind
>>> limits). Those reductions depend on RAID1 runtime state and mirror
>>> health, so they are not readily visible to the block layer during atomic
>>> write validation. In those cases RAID1 still needs to detect that the
>>> atomic write can no longer be serviced as requested and fail it
>>> appropriately.
>>
>> Sure, and we do this. As I remember, we should return -EIO in this case.
>>
> 
> Right, and that's the main motivation for this patch. The original
> atomic write support already returned -EIO for one bad-block path, but
> there are other cases where max_sectors can be reduced (e.g. the
> first_bad <= sector path and write-behind limits)
> 
> After a4c55c902670, those cases can end up completing with EINVAL or
> NOTSUPP instead. This patch is intended to restore consistent -EIO.
> 

ok, but I could not check this as I did not recognize the baseline code.

>>>
>>>>
>>>>> Along the way, the bio may instead
>>>>> fail due to other conditions and return a different status, even though
>>>>> the request was invalid as an atomic write from the beginning.
>>>>>
>>
>