Re: calibration_placeholder.c too many levels of symbolic links

Hi,

Thanks for the reply.

I tested with the VULCANO CVS. The error was not repeating.

I am able to build the rtai.


Thanks & Regards,
B.Thiyagarajan


On Thu, Mar 31, 2016 at 5:50 PM, Paolo Mantegazza <
[email protected]> wrote:

> I've just repeated the installation and I do not see such problem. Are you
> compiling it within the untarred directory of from outside?
> In any case, if you can, do me a favour, test with VULCANO CVS.
> The final 5.0 is surely going to be closer to it than to its previous test
> release.
> Paolo
>
>
> On 03/31/2016 01:53 PM, servo gmrt wrote:
>
> Hi,
>
> I am trying to complie RTAI-5.0 test release with Linux Kernel 3.18.22.
>
> When trying to compile the rtai, calibration_placeholder.c file is missing.
>
> The following error was reported.
>
> Too many levels of symbolic links
> make[7]: *** No rule to make target
> '/root/rtai-5.0-test1/base/sched/calibration_placeholder.c needed by
> '/root/rtai-5.0-test1/base/sched/calibration_placeholder.o'.  Stop.
>
> When I try to locate the source file. I could not find it.
>
> Kindly advice me to solve the issue.
>
>
> Thanks & Regards,
> B.Thiyagarajan
>
>
>
>
> _______________________________________________
> Rtai mailing [email protected]://mail.rtai.org/cgi-bin/mailman/listinfo/rtai
>
>
>

_______________________________________________
Rtai mailing list
[email protected]
https://mail.rtai.org/cgi-bin/mailman/listinfo/rtai