Re: So tanks. but i have a problem now!
"Ali Paikan" <[email protected]>
| Newsgroups | gmane.linux.real-time.rtlinux.general |
|---|---|
| Message-ID | <[email protected]> |
---------- Original Message ---------------------------------- From: Der Herr Hofrat <[email protected]> Date: Wed, 20 Oct 2004 08:24:21 +0200 (CEST) >2.4.18 I belive was not (yet) gcc-3.X.X clean so I guess thats your problem >you can use a later kernel+patch or use gcc-2.95.3/4 which should work. > >hofrat Tanks Mr.Hofrat! I use the gcc-2.96 and there is no problem with last error! But occurred a new error at finish. When compiler arrived here: Warning : kernel is too big for standalone boot from floppy If [ -f /vmlinuz ]; then mv /vmlinuz /vmlinuz.old; fi If [ -f /System.map ]; then mv / System.map / System.old; fi Cat bzImage > /vmlinuz Cp /usr/serc/rtlinux-3.2/linux-2.4.18/System.map / If [ -x /sbin/lilo ]; /sbin/lilo; else /etc/lilo/install; fi Warning: device 0x0308 exceeds 1024 cylinder limit Fatal: geo_comp_addr: cylinder number is too big ( 9138 > 1023 ) Make [1]: *** [zlilo] Error 1 Make [1]: leaving directory /usr/src/rtlinux-3.2/linux-2.4.18/arch/i386/boot Make : *** [bzlilo] Error 2 [root@localhost linux]# _ And when I configure my grub to boot from new kernel many of starting say [Failed] And system halts on this message: Starting system logger: I so great if you help me to install the RT-Linux successfully. Tanks. Paikan _______________________________________________ Rtl mailing list [email protected] http://www2.fsmlabs.com/mailman/listinfo/rtl